SCTD Problem with DoT
 

Hi,

i've been using SCT+SCTD for a while and it always worked fine. But now i have a problem, i created a Warlock and i noted that my damage over time aren't shown by SCTD.
It shows perfectly my Direct Damages (like shadow bolt) but when i casta DoT (like Corruption) on a monster, i see any damages/ticks.

Of course i tried with the last version of SCT+SCTD and also tried cleaning WTF&Interface but it didn't change anything, still can't see my indirect damages over time!!!

I've searched the forum but haven't found a solution so i'm asking you people: what must i do? i still can play but not being able to see DoT for a warlock isnt cool :(

Thanks!

Hi, there
 

Hello,
I'm havin the same probleme and i still don't get any dots shown.


Any one help is welcome :( HEEEEEEEELLLLLLLPPPPPP :D

Its been a while since I used SCT(D) so I cannot direct you to the exact place.

But there is an option in there to show DoT/HoT

I think they are turned off by default because they get very spammy (especially for a healer casting a HoT on many different targets)

Yeah i saw that and tried everything possible with options but DoTs still don't show.. Well nevermind, i learnt playing without'em :D

check that the 'slider' under the show hots/dots isn't turned down up too high.

I remember being able to set it so it ignored all hots/dots that done less than say 100 damage/healing per tick, etc

I know it does work and its in there somewhere, cause it used to show my dots, but now I use MSBT and I can't remember exactly where the options are in sct anymore

I had some problems too with SCT/SCTD, but the reset buttons from the menu solved most of them and reconfiguration was a very good solution. try it and maybe will help you too.