|
Well I got the possession working for the zombies, but when I switched to my druid to set up some standard stance bars I had no luck. When I shift nothing happens, it stays on ActionBar:1.
I used exactly what was listed:
"[actionbar:1];[stance:1];[stance:3];[stance:3,stealth]"
Tried making a fresh bar and doing nothing but that custom line, etc., etc.
Whenever I go back to look at it the custom lines have changed to:
"[actionbar:1]
[stance:1]
[stance:3]
[stance:3,stealth]"
The semicolons are gone and it gives them their own line. Not sure if it's supposed to do that, but I've tried rewriting it over and over so it has semicolons and all on one line... but it always reverts back to that.
Sorry if this was covered else where, thanks.
After testing:
"[stance:1]
[stance:3]
[actionbar:1]"
Oddly, works for the forms, defaulting to AB1 when not in a form. I couldn't get anything to work while using prowl/stealth keywords.
Also "possess" isn't know for the custom, what should be used instead?
Just trying to make a caster/cat/cat(prowl)/bear/possess bar. I must be missing something obvious. I hope.
|