"objectives" panel not scaling

[whistledown]

ok i have the addon where it moves the minimap to the side panel, with my map there the quest objectives panel only show about 2 or 3 quest at a time

ive tried using /nui movers to see if the panel is behind something but its not

i added a screen shot to show the panel its in the upper left

not sure how to fix other than disabiling the minimap mover

[Xrystal]

I'll have a look later on when I get online and see if I can figure out the problem. I can't see why one plugin will affect the default frames like the objectives frame. As far as I know all Scott has nUI do with the default frames is make them movable.

[Xrystal]

Okay, I can see a problem immediately when I log onto the character I used yesterday with no problems and now .. see image 1.

nUI movers won't let me move the objectives frame at all.. so, I disabled the minimap plugin and all of a sudden nUI's management of the minimap was turned off. Resulting in the following movers setup.. see image 2.

Then if I turn on nui's management again image 3 shows that it has detached the objectives frame from the right and put it in the left, size still as expected.

Despite the little problems I mentioned above I suspect the size of the mover frame is relative to the size of the objectives screen at the time the movers system was triggered.. so if you were not tracking anything at the time it might well have been a smaller frame.

Okay, dabbled with the minimap option that is set to false in the minimap plugin and set to true in nUI proper and found that it has to be false for the plugin to put the map in the infopanel which, seems to then make the objectives frame attach to the minimap frame as per the minimap toggle.

I'm not sure what can be done to fix this though short of using an objectives addon that detaches the objectives frame from the minimap.

One thing to note though is that the minimap option toggle for nUI also affects my scrolling watch frame addon that has an ability to dock inside the infopanel... what it does with this option though is to ignore the docking procedure and just docks the outer scrolling frame and leaves the objectives frame somewhere else and invisible from what I could see .. or not see as the case may be.